12:11. Removal and installation of lowering glass of a forward door
Removal
|
|
Removal of lowering glass of a forward door |
Models with a body the sedan and the station wagon
|
|
- Establish lowering glass against a window of a framework of a door and turn off bolts of fastening of guides of a window regulator.
- Remove internal and external a sealant from the top part of a door, an external rear-view mirror from the left door and internal facing of the right door. Remove also a molding.
- Lift a back part of glass, give it forward and take out it at the top a doorway.
- Installation is made as it should be, the return to removal. Before an inhaling of bolts of fastening of a guide of a window regulator completely lower glass, enter it into a fillet pressure forward, at the same time wringing out a guide back, and tighten bolts. Completely lift glass and weaken bolts of fastening of a back fillet. Wring out glass back in fillets and tighten bolts.
|
|
Models with a compartment body
|
|
- Take out internal a sealant from the top part of a door.
- Unscrew screws of fastening and remove the top and lower emphasis from the back directing fillet.
- Turn off the lower nut and the top bolt, and then remove the back directing glass fillet.
- Unscrew screws of fastening and remove the back directing wedge.
- Give glass back and take out it from a door.
|
|
Installation
Installation is made as it should be, the return to removal. At the same time adjust the provision of glass as follows.
|
|
- Adjust position of the forward holder of a guide so that he slightly concerned sealing laying after closing of a door.
- Make sure that at the lifted glass its forward edge coincides with the holder of a guide.
- If necessary adjust the provision of the top emphasis, fillets and guides of a window regulator.
- Adjustment in the side relation is conducted by the directing pins. At completely lowered glass its top edge has to be aflush with sealants — adjustment is made by emphasis shift on a window regulator guide.
- Adjust the provision of the directing wedge so that it concerned a back edge of glass. In conclusion apply a small amount of anticorrosive lubricant on an internal surface of fillets.
|
|