2.3.2.6. Removal and installation of the VMT sensor

The VMT sensor (see a photo in "A performance order")

1 — an arm
2 — a block
3 — the VMT sensor

4 — an arm of fastening of the sensor
5 — a contact pin
6 — a template


Template for installation of the VMT sensor


 PERFORMANCE ORDER

  1. Disconnect an arm 1 from a box.
  2. Disconnect a block 2.
  1. Take out up the BMT 3 sensor from an arm 4.
  2. Weaken bolts of fastening of an arm 4.
  1. Put on a template 6 (to make according to the enclosed drawing) a contact pin 5.
  2. To bring the VMT sensor against the stop in a template.
  3. In this situation tighten bolts of fastening of an arm 4 (see above).
  1. At installation of the VMT sensor provide coincidence of a tag FROM (the provision of VMT) on an engine flywheel with inflow on a gas distribution mechanism drive cover.