2.8.4. Removal of the power unit
Suspension of the power unit
Removal of the power unit
- Put a cowl in vertical position.
- Disconnect a wire of "weight" from the rechargeable battery.
- Remove the lower guard of the engine.
- Merge oil from the engine.
- Merge cooling liquid.
- Remove the air filter with a zabornik of cold air.
- Remove a radiator, having wrung out spring latches in its top part.
- On cars with the regulator of provision of a body remove the pump of the regulator of provision of a body.
- On cars with the hydraulic booster of steering suck away the syringe liquid from a tank of the hydraulic booster and disconnect hoses from the pump of the hydraulic booster.
- Disconnect draft of the drive of a butterfly valve.
- Disconnect from the engine hoses of a supply and removal of liquid to a radiator, a heater and a broad tank.
- Disconnect vacuum hoses from power supply system elements.
- Disconnect from the regulator of pressure and the batcher of fuel or from the carburetor hoses of a supply and discharge of fuel.
- Remove draft of the drive of a butterfly valve.
- On cars remove draft of regulation of the operating pressure from automatic KP.
- Disconnect wires from a starter and the generator. Disconnect low-voltage wires and the wire of high voltage going to the ignition coil from the ignition sensor distributor.
- Disconnect wires from all sensors, and on engines with system of injection and from the trailer switch of a butterfly valve, and from the sensor of provision of a pressure head disk of a flowmeter of air.
- Remove a block of diagnostics and disconnect behind from a block a VMT sensor wire.
- Disconnect a crossing point on "mass" of the engine.
- Disconnect the driveshaft from a flange of a secondary shaft of the transmission.
- Depending on a complete set remove the shock-absorber of the engine and the forward buffer.
- Turn off bolts of fastening of a reception pipe of mufflers to a final collector and remove an arm of fastening of a reception pipe to the transmission.
- Disconnect a coupling hydraulic actuator hose from the union on a body.
- On cars from automatic KP disconnect draft of the electromagnetic valve of compulsory return switching; disconnect draft of gear shifting from the lever; to a rasstykuyta the socket of the switch of blocking of a starter the screw-driver inserted between a latch and wires; unscrew the engine loading sensor socket.
- Turn off bolts of fastening of arms of an engine mount to a forward cross beam and an arm of fastening of KP to a back cross-piece.
- Hook on waist slings for an engine eye bolts.
- Remove a back cross-piece.
- Incline the power unit back at an angle about 45 ° and bring it out of a compartment, avoiding damage of the oil pump.
- Remove the power unit.