2.8.8.3. Removal and installation of the water pump


Removal

 PERFORMANCE ORDER

  1. Disconnect a wire of "weight" from the rechargeable battery.
  2. Merge cooling liquid.
  3. Remove collars and disconnect hoses from a radiator.
  4. Remove the thermostat case with the hose going to the water pump.
  5. Depending on a complete set disconnect a hose of the block of heating of the carburetor, having exempted from fastening to the inlet pipeline.
  6. Remove the fan.
  7. Take off a belt of the drive of the water pump.
  8. Remove a pulley. In case of difficulty screw M10x1 bolt stripper in a nave.
  9. Remove the magnetic case of the coupling of the fan.
  10. Remove the generator with an arm, without disconnecting wires, and fix it in a motor compartment.
  11. Remove the water pump, having turned off bolts of its fastening.
  12. Clear and check a condition of all details. Do not smooth out the interfaced surface of the water pump any tool or abrasive material.


Installation

 PERFORMANCE ORDER

  1. Put laying on the case of the water pump and wrap two screws or apply on the interfaced surface sealant like "Loctite 518"
  2. Install the water pump and wrap fastening bolts, except for bolts of fastening of an arm of the generator.
  3. Establish an arm of the generator and the magnetic case of the coupling of the fan.
  4. Tighten all bolts of fastening of the water pump.
  5. Establish a pulley of the water pump.
  6. Put on a belt of the drive of the water pump and adjust its tension.
  7. Put on the fan a nave.
  8. On carburetor engines attach a hose of the block of heating of the carburetor.
  9. Install the thermostat case, previously having replaced laying.
  10. Attach hoses and tighten collars.
  11. Fill in liquid, attach a wire of "weight" to the rechargeable battery and remove air from the cooling system.