2.8.8.6. Installation and adjustment of a tension of a belt


Installation of a mnogoruchyevy belt of the drive of auxiliary units

And — on cars without hydraulic booster of steering
B — on cars with the hydraulic booster of steering
In — on cars with the hydraulic booster of steering and the conditioner

1 — a pulley of a bent shaft
2 — a generator drive pulley
3 — a pulley of the drive of the water pump

4 — a pulley of the drive of the pump of the hydraulic booster of steering
5 — a conditioner compressor drive pulley
6 — a tension roller


Sequence of removal of bolts of fastening of the camshaft of the engine M 110

Tags for a tension of a belt of the drive of auxiliary units on a tension roller of the engine M 102.982. For a tension of a belt turn off a nut 482 on 1/4 turns and turn a nut 481 to the right before coincidence of an adjusting pin to a tag (the 5th for cars without hydraulic booster of steering and with the 7th with the hydraulic booster of steering or the compressor of the conditioner) then tighten a nut 482.

Adjustment of a tension of a mnogoruchyevy belt of the drive of auxiliary units

1 — a bolt of fastening of a tension roller
2 — an adjusting bolt of a tension roller


 PERFORMANCE ORDER

  1. Put on a generator drive belt pulleys.
  2. Make sure that the tension roller is in a starting position for adjustment.
  3. Put the index of adjustment of a tension of a belt opposite to zero division of a scale.
  4. Tighten an adjusting bolt of a tension roller so that the index of adjustment of a tension of a belt appeared opposite to the 7th division of a scale (or the 5th on cars without hydraulic booster of steering).
  5. Tighten a bolt of fastening of a tension roller.