4.4.3. Four-stage and five-step KP

 PERFORMANCE ORDER

  1. By means of a mandrel to a napressuyta a worm gear wheel of the drive of a speedometer on a secondary shaft so that its end with a facet was turned back.
  2. Establish a back cover with new laying and the necessary moment, evenly tighten bolts.
  3. Napressuyte a flange of a secondary shaft on vents of a secondary shaft. Fix it by a nut, having tightened it the moment 15,0 кгс.м, holding a flange the metal core fixed on it by a bolt. If it is provided, you zakontrit a nut zachekanky its fillet in a groove.
  4. Establish a forward cover together with adjusting laying and sealing laying and tighten bolts. In case of replacement of the bearing of a main shaft adjust a face gap of an external ring of the bearing within 0,0 — 0,05 mm. If the bearing of an intermediate shaft was replaced, adjust a face gap of an external ring of the bearing within 0,07 — 0,15 mm. For definition of a gap the caliper with the nonius measures distance from zaplechik of a cover, a ring of the bearing or a lock ring of the bearing to the interfaced surface, but at the same time to the sizes of a cover it is necessary to add thickness of the compressed sealing laying. The carving of bolts of a cover should be greased with sealant.
  5. Put forks of gear shifting and a rod of the choice of transfer of a backing and the V transfer to neutral situation, then push a rod of the choice of transfer of a backing and the V transfer approximately on 25,00 mm through a cover.
  6. Establish a gear shifting mechanism cover with new sealing laying, at the same time hooking on a finger of inclusion of transfer of a backing and the V transfer with a clamp and switching forks — with leads. Grease a carving of bolts with sealant, screw and tighten them.
  7. Put a washer on a rod of inclusion of transfer of a backing and the V transfer and establish a spring lock ring.
  8. Napressuyte the gear shifting lever on vents in the situation noted earlier also tighten a coupling bolt.
  9. Fill in oil in the transmission to bottom edge of a jellied mouth and tighten a stopper.
  10. Install squeezing the lever and the bearing of coupling.