4.5. Adjustment of the drive of gear shifting (from the lever on the body floor tunnel)


The details of the mechanism of gear shifting which are placed in a car floor

1 — the gear shifting lever
2 — the translated lever
3 — a press spring
4 — the plug
5 — a hollow adjusting pin
6 — a cover
7 — a cuff of the translated lever
8 — a nut
9 — the bearing arm
10 — a press spring
11 — a tube
12 — a pin in a tube
13 — the shock-absorbing plug
14 — the directing ram
16 — a bearing cover
20 — the springing washer
21 — a bolt with a six-sided head
22 — light switch

23 — the plug
24, 26, 30 — washers
26a — a cup spring
27 — the intermediate lever of transfer of a backing
28 — the intermediate lever I and II of transfers
29 — the intermediate lever III and IV of transfers
31 — translated draft of transfer of a backing
32 — translated draft of I and II transfers
32a — the translated lever I and II of transfers
33 — translated draft III and IV transfers
33a — the translated lever III and IV of transfers
34 — a draft head
35 — a six-sided nut
36 — the plug
37 — a clip
38 — laying


 PERFORMANCE ORDER

  1. Tighten the parking brake, lift a jack in front of the car and put it on the emphasis substituted under the forward bridge.
  2. Remove clips and disconnect drafts from the lower end of the lever of the drive of gear shifting.
  3. Block the gear shifting lever in neutral situation, having inserted a pin with a diameter of 6 mm into the opening provided for this purpose.
  4. Having put the gear shifting lever in neutral position, check the adjusting sizes.
  5. After that it is possible to return the lever to a starting position.