6.2. Cardan transfer
Cross-section of the central bearing of the leading shaft
Removal and installation
Removal
|
- Lift the car.
- Remove the final pipeline.
- Turn off bolts of fastening and remove a guard from the body bottom.
- Disconnect cables of the parking brake and remove the lever mechanism from the body bottom.
- Applying two keys, to weaken on two turns a coupling nut on the forward end of the driveshaft. It will allow to displace in bulk several.
- Mark position of the driveshaft and elastic couplings (chalk, paint).
- Turn off bolts of fastening of an intermediate support, forward and back flexible couplings from the transmission and the main transfer. Lower an intermediate support on a support (jack).
- Record the mutual provision of shlitsevy connections (paint) further to provide balancing of the driveshaft.
- Shift the back driveshaft forward and disconnect it from a flange of the main transfer.
- Disconnect the forward driveshaft from a flange of the transmission and take out cardan transfer assembled from under the car and put on a support (tarpaulin), without separating driveshafts from each other.
|
|
Installation
You carry out installation in the return sequence.
|
- Put 6 g of refractory lubricant in the central deepening of each of the aligning plugs.
- Insert connecting bolts heads towards an average support and screw new самоконтрящиеся nuts.
- Several times turn the leading shaft to remove stress. Check that forward and back parts (sections) did not jam, then tighten a coupling nut the moment 10,0 кгс.м.
- Finally tighten bolts of the central bearing.
- Establish wheels and lower the car.
|
|