6.3.5. Replacement of an epiploon of a shaft of the drive of a back wheel

Installation of an epiploon of a shaft of the drive of a wheel in a cover of the bearing of models of early releases

Installation of an epiploon of a shaft of the drive of a wheel in a cover of the bearing of models of later releases


 PERFORMANCE ORDER

  1. Remove the necessary shaft of the drive of a wheel as it was described earlier.
  2. Take out the screw-driver an epiploon.
  3. Clear landing surfaces, with wear of a surface of a shaft it is necessary to replace a shaft.
  4. Slightly oil external and the condensing edges of a new epiploon, and then by means of a mandrel press an epiploon in a cover of the bearing or a case.
  5. Establish a wheel drive shaft as it is specified earlier.