7.7. Removal, dismantling and installation of a rotary fist

 PERFORMANCE ORDER

  1. Prepare the car (see Removal and installation of springs of a forward suspension bracket, Check, removal and installation of shock-absorbers, Removal and installation of a bar of the forward stabilizer of cross stability, Removal and installation of a forward suspension bracket assembled and Removal, installation and adjustment of a nave and bearings of forward wheels) and remove a wheel.
  2. Turn off a bolt of fastening of the rotary lever to the lower part of a rotary fist.
  3. Remove a brake bracket.
  4. Remove a nave of a forward wheel.
  5. Substitute a jack cart under the lower lever of a suspension bracket, turn off a nut of the top spherical hinge and by means of a stripper separate the top lever of a suspension bracket.
  6. Turn off a nut of the lower spherical hinge and by means of a stripper separate a rotary fist from the lower lever of a suspension bracket.
  7. Turn off bolts of fastening and remove a board of a brake disk from a brake fist.
  8. Carry out fault detection of spherical hinges, pay special attention them to an axial side play. Replace the damaged covers, and fill hinges new lubricant.
  9. At wear of the lower spherical hinge it needs to be replaced, at wear of the top spherical hinge it is necessary to replace the top lever of a suspension bracket assembled.

Installation of a rotary fist is made as it should be, the return to removal.