7.9. Removal and installation of the lower lever of a forward suspension bracket

 PERFORMANCE ORDER

  1. Remove the shock-absorber and a spring of a forward suspension bracket.
  2. Turn off a nut of a tip of draft of steering and a stripper disconnect a draft tip from a rotary fist.
  3. Turn off a bolt of fastening of auxiliary thirst for a body.
  4. Record the provision of disks of an internal eccentric bolt of the lower lever of a suspension bracket of rather cross beam, then turn off a nut and remove disks and a bolt.
  5. Turn off a nut of the lower spherical hinge of a rotary fist and a stripper disconnect the lower lever of a suspension bracket.
  6. Remove the lower lever of a suspension bracket together with auxiliary draft.
  7. Turn off a bolt of fastening and separate a basic cup of a spring of a suspension bracket from the lower lever.
  8. Record mutual position of the lower lever and auxiliary draft in knot of fastening and separate these details from each other.
  9. Carry out fault detection of details. In case of wear of the spherical hinge replace the lower lever of a suspension bracket assembled.
  10. For replacement of rollers of auxiliary draft remove caps, rubber laying and install new details in the suspension bracket lever.
  11. For replacement of internal rubber plugs of knot of fastening take out at first old plugs, using as necessary a drill (hacksaw) for their cutting. Clear internal diameter, ship new rubber plugs in soap water and press them in suspension bracket levers a vice so that their external fillets settled down vertically.

Installation is made as it should be, the return to removal. At the same time the final inhaling of bolts and nuts is made on the lowered car. In conclusion check the angles of installation of forward wheels.