8.3. Removal and installation of the back stabilizer of cross stability
|
For cars with system of regulation of provision of a body these works are carried out only by the expert HUNDRED. |
|
Section of knot of fastening of the stabilizer of cross stability |
Removal
|
- Lift a back part of the car and expose it on a support (support), having enclosed an emphasis under forward wheels.
- On the cars equipped with system of regulation of provision of a body turn off nuts and disconnect draft of management, having noted its situation on a stabilizer bar.
- Remove back wheels.
- Turn off nuts of fastening of tips of a bar of the stabilizer to connecting links and take out links.
- Turn off bolts of fastening of a collar to a body and remove plates and rubber plugs of fastening.
- Disconnect rubber plugs of fastening of an exhaust pipe and lower its back part on a support.
- Take the stabilizer of cross stability from under the car.
- Carry out fault detection of details and in case of need replace them.
|
|
Installation
Installation is made as it should be, the return to removal with placement of points of a bend of a bar of the stabilizer according to design documentation (it is specified by an arrow).
|
Correct installation of the stabilizer of cross stability of a back suspension bracket |
|
- Do not tighten finally nuts and bolts of fastening to full load of a suspension bracket the mass of the equipped car.
- Expose draft of level of system of regulation of provision of a body on HUNDRED.
|
|