- Remove the shock-absorber of a back suspension bracket or a depreciation rack (on cars with system of regulation of provision of a body).
- Install the device for compression of springs on a suspension bracket spring. For this purpose squeeze to the full a spring the jack cart substituted under the diagonal lever of a suspension bracket, and then install adaptation on five rounds of a spring.
- Lower the diagonal lever of a suspension bracket on height sufficient for removal of a spring back a suspension bracket together with a rubber pillow of the top support.
- Remove a rubber pillow of a support and release the device for compression of springs if it is necessary.
- Clear the top and lower support of a spring.
- Installation is made as it should be, the return to removal. At the same time you watch that the lower end of a spring entered a special groove of the diagonal lever of a suspension bracket. Tighten nuts of fastening of the shock-absorber after loading of a suspension bracket the mass of the car.
|
|