8.5. Removal and installation of a back suspension bracket assembled

 PERFORMANCE ORDER

  1. Lift a back part of the car and put it on support (supports). Enclose wedges under forward wheels.
  2. Remove an exhaust pipe.
  3. Depending on a complete set turn off bolts of fastening and remove a heat-shielding guard from the body bottom, then remove cables of the drive of the parking brake.
  4. Disconnect flexible hoses of a hydraulic actuator of brakes from brake brackets of back wheels, and then establish caps.
  5. Remove cardan transfer.
  6. Remove springs of a back suspension bracket.
  7. Turn off nuts of fastening of the stabilizer of cross resistance to connecting links and remove links.
  8. Depending on a complete set disconnect wires of the sensor of anti-blocking system of brakes behind a back of a back seat and take away them down.
  9. Substitute under a back suspension bracket (assembled) a jack cart.
  10. Turn off bolts of fastening of forward arms to the body bottom.
  11. Turn off the fastening bolts located behind the back bridge to a body of knots of a suspension bracket.
  12. Lower a back suspension bracket assembled and bring it out of the car.
  13. You make installation as it should be, the return to removal, tightening bolts and nuts the set moment and replacing самоконтрящиеся bolts of fastening of back knots. Remove air from a hydraulic actuator of the brake system and adjust the parking brake.